Shop air power push/pull system
Dual rigid chain push/pull for single stroke die transfers
Rocker switch push/pull control on hand-held pendant
Gravity rollers for low friction die transfers
Side guides for centering lower common plate with the press centerline
FRL and LOTO on air inlet
Swing-open bolster extensions for personnel access to the press
CART CONTROL – Fork pockets to transfer table to press or storage
DECK TRANSFER – Pneumatic powered rigid chain push/pull transfer system with custom grippers
TOP SURFACE – Gravity rollers to assist transfer
COLOR – Safety Green
4 x 15,000 lbs. Capacity
2x 15,000 lbs. Capacity
Two die load stations back to back to allow pre-staging new die
Foot activated lock release
Gravity swing stop provides fail safe operation unless aligned with press
Ergonomic handle grips for easy control
DRIVE – Manual
DECK SURFACE – Inline Gravity Rollers
2 x 6,600 lbs. Capacity
Two die load stations back to back to allow pre-staging new die
Foot activated lock release
Gravity swing stop provides fail safe operation unless aligned with press
Ergonomic handle grips for easy control
DRIVE – Manual
DECK SURFACE – Heavy Duty Gravity Rollers
2 x 1,200 lbs. Capacity
Heavy duty welded frames
Foot activated lock release
Gravity fail safe transfer side stops
Lag & level provisions
DRIVE – Manual
DECK SURFACE – Heavy duty gravity rollers
2 x 4,000 lbs. Capacity
9 x 5,000 lbs. Capacity
• Two position shuttle deck on floor mounted base
• Air powered gearmotor linear drive
• Powered lock pin to retain shuttle deck in either transfer location
• Powered dual rigid chain push/pull system
• Operator control panel & pendant controller on 8’ tether
• Powered die stops at transfer end of both stations
• Extention bridges
