HIGH QUALITY TITAN DIE LIFTERS

Green Valley Manufacturing has developed a standard line of Pneumatic Die lifters for stamping, and vertical molding presses. GVMI die lifters enable the tool to be elevated above the press bed surface on rollers for easy transfer to/from the press.

The pneumatic operation ensures a clean application without any of the oily mess associated with hydraulic units. The systems are economical and simple to install and operate.

Delivery time: 3-4 weeks.

BENEFITS

  • Simple Installation
  • No Oily Mess
  • Economical
  • Low Friction Die Transfers To/From Press
Pneumatic Die Lifter in Press Bed

Even though we advertise these die lifters as standard ¾” and 1” t-slot die lifters, all lifters are cut to length and made to order based on the end user’s specific t-slot dimensions.  Many times a bolster has been machined down (resurfaced) and the t-slot is shallower.  Even on new bolsters we require the t-slot dimensions due to the large variation in standard ANSI t-slot tolerance specifications.  The dimensions needed are shown on the sketch below and on our brochure.  GVMI will use the provided t-slot dimensions to accurately locate the roller elevation for optimum system performance.

ORDERING INFORMATION & PRICING

Specify T-Slot Dimensions for each Press System on your order:
A, B, C, and D per this sketch on your order.

Lift Capacity

Die lifter capacity at 80 psi:
¾” die lifters can lift 750 lb. per foot (use die F-B length X number of supporting die lifters).
1” die lifters can lift 1000 lb. per foot (use die F-B length X number of supporting die lifters).
Part NumberDescription
2PAB2-port manifold block
4PAB4-port manifold block
6PAB6-port manifold block
8PAB8-port manifold block
075die lifter for std. ¾” or 22mm t-slot *
100die lifter for std. 1” or 28mm t-slot *
SS100slug shield option
SS075slug shield option

All manifolds come with 3/8” NPT female connector for shop air supply, one slide valve, and straight 1/4” tubing
push-lock connectors for air out to die lifters.

Each die lifter will contain a push-lock 90° elbow and 24” of 1/4” tubing to connect to manifold selected above.

* Include drawing with dimensions of your T-slot with your order.

Order
Your purchase order should list quantity and part number of the manifold(s), and quantity and length of each die lifter segment.

Note: Include detailed T-Slot dimensions for each press system.
Example: one pair of ¾” X 30” die lifters and one 2-port manifold block will be purchased as shown.

ItemPart NumberQuantityDescription
12PAB12-port manifold block
2075230” die lifter for std. ¾” t-slot